donniefitz2

That article was so poorly written, I struggled to get through it, save for my interest in Malick. What a half baked analysis of Thin Red Line. There's just so much more going on in that movie than the author gives credit for.

Self-employed since 2020. I'm basically a software consultant doing hands on software development in the .Net world.

Not sure about this. I searched for my own podcast, The GMRS Podcast, and the suggestions were all over the place. The Tournament Poker Podcast being number one followed by a Magic The Gathering podcast and some automotive stuff. Needs work.

It seems like it would be pretty easy to stand near one of these with a frequency counter, or even a handheld Yeasu FT-60 and find out what frequency it's using. It would be very clear if it was relaying data or voice as well. From there you could take that frequency and figure who would be using it and what for.

Unfortunately that's the only one I know of with an app interface. I did reverse engineer the app and tried to get some cooperation with the manufacturer of the radio to create an app of my own, but they weren't interested.

I'm pretty deep into radio and never in a million years would have thought I would be. I even remember giving a co-worker a hard time for getting his ham radio license. Now, I'm a full-fledged GMRS and ham nerd.

1) It's worth getting into for 3 reasons: emergency communications, learning about some very interesting technical things like how antennas work, networked repeater systems, and there's a social aspect to talking with others on simplex and repeaters. Radio is far more technical than I ever realized and it's a very deep topic.

2) There are some good YouTube channels that can give you a quick overview of what's possible (Ham Radio Crash Course, Ham Radio 2.0) I also have a podcast where I talk about GMRS (similar to ham but very limited) at gmrs.fm

You might be surprised at how interesting radio can be. I was.

TIDRadio make something similar to this with a Bluetooth interface instead of the cable. It's a decent piece of hardware, but the app is pretty bad and limited.

There's a market in ham radio for a Bluetooth interface to replace the ancient programming cables and software we all use for both HT's and mobile transceivers.

One radio does this (the VGC VR-N7500), the interface for the entire radio is an app, but the app again is horribly designed. If it were some kind of open protocol, app developers could do some truly interesting things with it.

This is exactly what I thought when I saw that title. And I was just measuring the SWR of my roof-mounted omni antenna.

I always wondered how DarkSky got that "hyperlocal" weather data. After getting into amateur radio and learning about APRS, I'm thinking they used APRS weather beacons to obtain that data. If not, it sure would be good source for very localized weather in an app.

For anyone interested in more info about IF, Dr. Jason Fung has a great book about it.

https://www.amazon.com/Obesity-Code-Unlocking-Secrets-Weight...

I...third this. Autosleep is a very well put together app and it's incredibly useful.

I haven't read anything profound or non-obvious on this topic and there's a lot written about it.

The one thing I have learned creating and trying to get a 2 sided marketplace off the ground (https://gearoffer.com) is that it's excruciating, painful and nearly impossible.

The one thing you must have is perseverance. A lot of perseverance.

An excellent movie. I've watched it twice and will likely watch it again.

I think some of this slowdown is due to reaching "peak sensor". Much of the frenzy back in 2007-2012 was due to big advancements in sensor technology, namely, low-light performance. But now, my Fuji X100, which came out in 2011 still shoots great images, even in low light. And my Fuji X-H1 will be very adequate for the next 5-8 years.

As camera sensors became better, the need to replace them with the next model diminished.

Much of what camera makers are now producing are features on top of already great sensor technology. I don't think most consumers care about these additional features.

Some of the best info on this can be found in the book, The Obesity Code by Dr. Jason Fung.

Also, here's a short video by him: https://www.youtube.com/watch?v=tIuj-oMN-Fk

I've been doing IF and LCHF for a few months now too. Previously, I only did Keto (no IF) and lost 70 pounds but later put some back on.

The biggest benefit to me from IF isn't the weight loss, it's the increased energy level. I don't know how it works, but I have way more energy, consistently, after routinely fasting.

I'm founder of a similar 2 sided marketplace addressing the same market, but for buying and selling (https://gearoffer.com).

KitSplit likely has a fraud problem that's much larger than they admit. Even at our small scale, we often get fraud attempts. The key is to adapt the platform once you find a hole. Otherwise, these fraudsters will come back, frequently. If KitSplit tout their ability to prevent fraud in the first place, but this person was able to find a long list of other victims, I'm guessing KitSplit isn't plugging the holes and this type of scam will continue.

Would this cover a marketplace scenario? For instance, we use Connect and transfer a purchase balance to our Connect account users after a purchase is made. If we encounter a chargeback, we also have to come up with the full cost of the item sold to cover the loss because the seller has already been paid. I'm wondering if this new service would cover that scenario.

It's a pre-production camera. Typically reviewers don't get to see anything but JPEGs until it's released.

C#, .Net Core, Postgres. Really liking the Marten DB abstraction over Postgres.

I had to copy the text and paste it into Notepad to actually read the article.

I am working on a peer-to-peer marketplace for buying and selling used camera gear. Currently, the only way to do this is via Craig's List, Ebay or forums. We're creating dedicated marketplace and we'll be facilitating secure transactions among buyers and sellers. It's going to be a long road. If interested, you can sign up for early access here: http://gearoffer.com

With Xamarin, you can use it with both Xamarin Studio and Visual Studio. I believe XS is free now and you can get VS Community for free too.

I'm using it for a few projects. One for a client on the side and one for my primary job. It's really nice to work with. There are issues here and there, but overall, it's a very viable solution and I'm quite happy with it.

Same here. I lost 75 pounds on the keto diet. It's not so much a diet for me anymore, it's just how I eat. I wrote about my experience here: https://thedon.me/2015/10/07/i-lost-63-pounds-heres-how/

Wow. This good stuff. Thanks for sharing.

Sorry, Everyone!

Stagnent Engineer

I have updated several machines and had no problem at all.

I wonder if these management classes Google implemented are online somewhere. It would be nice to be able to view them.