We've successfully used a Delta Tau real-time Linux motion controller to run a 24 kHz laser galvo system. It's ostensibly good for 25 microsecond loop rates, and pretty intolerant of jitter (you could delay a measurement by a full loop period if you're early). And the processor is a fixed frequency Arm industrial deal that only runs at 1.2 GHz.

Perhaps even that's not an example of such a system, 0.3 microseconds is close to the allowable real-time budget, and QC would probably not scrap a $20k part if you were off by that much once.

But in practice, every time I've heard "soft real time" suggested, the failure mode is not a sub-microsecond miss but a 100 millisecond plus deadlock, where a hardware watchdog would be needed to drop the whole system offline and probably crash the tool (hopefully fusing at the tool instead of destroying spindle bearings, axis ball screws, or motors and gearboxes) and scrap the part.