Just curious – why is range limited by a protocol? Why couldn't you send Bluetooth over hundreds of miles with a big enough antenna, for example?
Another way to make a signal go further is to transmit at a lower data rate (thus spreading your signal out over time so that in effect you have more power in the signal). The FCC limits "dwell time" in a single channel to .4s in the 900MHz band.
Yet another way to increase range is to increase your receive sensitivity. Lora's Chirp Spread Spectrum coding actually allows signals to be received below the noise floor. You can liken this to decrypting data: to an observer the signal looks like noise, but if you know how to look within the noise you can pull the actual coded information out.
All of these LPWAN technologies use different forms of coding and signal spreading over time to get long range. Note how spreading your signal over time means your throughput goes down.
The limit is actually 4W ERP (1 watt transmit + 6dB antenna gain) per CFR 15.247: https://www.law.cornell.edu/cfr/text/47/15.247
If you are aware of an exception to this, I would be very interested.
BLE; you're talking about power requirements of ~10mA transmit (current consumption), and averages in the <10μA range. That's the whole point of the tech. It's stuff that can run for years on a watch battery.
Now: how LORA is accomplishing such crazy long ranges when supposedly consuming similar amounts of current goes a little beyond my understanding of RF. There are a few people commenting in this thread that seem to have the knowledge, though!
It's probably easiest to explain how this works with conventional narrowband digital modulation schemes. For a typical modulation scheme, the bandwidth of the modulated signal is proportional to the bitrate. There's also some minimum signal-to-noise ratio below which the receiver can't decode it. By sending more slowly, you get a narrower signal, which means that the receiver can listen to a narrower slice of spectrum. Even though the received signal's no more powerful than before, because the receiver is no longer hearing all the noise outside of that narrower band the SNR improves and it can decode much weaker signals.
LORA appears to use direct-sequence spread spectrum, which basically means that the transmitter applies a spreading code to convert the narrow signal to a very wide one and the receiver uses the same code to despread it again and pick out the signal. Its range improvement is still based on the exact same principle of speaking very slowly to improve your SNR though.