PCIe doesn't have to be over an edge connector. PMC and XMC standards use board-to-board stacking. You can also do PCIe over cabling.
What's the point of low speed single ended I/O into an FPGA module? Seems like a waste of effort.
What's the point of low speed single ended I/O into an FPGA module? Seems like a waste of effort.
As for why to use single end low speed I/O, I guess it's about perspective. For some, an FPGA is something that sits on a PCIe bus or network. For a lot of people, it's a lot more than that. Something that talks to countless chips that maybe need spi, i2c, uart, or something custom.
For example, think about all those 1 wire LED strips and how it easy it would be to do that in HDL compared to the other approaches. Being and to work easily with bits vs bytes has huge advantages for custom interfaces. Another example: one time a group I was working with wanted to talk to battery management modules. Each one had a uart and they had to get daisy chained together, complicating things a lot. An FPGA with more than a few uarts is trivial and could've talked to each one independently. Even the highest end micros have maybe at most 20. You could fit 16 on 1 of these connectors. The UART block from Xilinx is on the order of 100 flops. You could have literally hundreds of uarts. Not that I have seen a need for that, but who knows, maybe someone does.
Getting rambley but another option is for test devices. Let's say you have a device that has a low speed interface and you want to test a lot of them at a time. You could use a bunch of multiplexors and time division control logic, or slap down an FPGA and do them all at once.
Hardware interfacing with the physical world. Driving small numbers of LEDs, h-bridge drivers, load switches, regulator control signals, reading buttons, accelerometers, gyroscopes, magnetometers, PWM controllers, GPS, ...
The lower speed Syzygy standard, while not operating at these speeds, is capable of much higher rates than a typical microcontroller. There are many peripherals with I/O requirements beyond a simple LED or SPI device, but below that of a PCIe or other high rate transceiver such has:
- moderate to high end ADCs and DACs (LVDS and parallel)
- image sensors (LVDS, parallel, and HiSPI)
- various networking PHYs
The lower end syzygy connector has pinouts to support LVDS differential pairs, which can easily achieve hundreds of Mbps data rates.