In washing machine application the locking action is quite fast as the heating element is PTC connected more or less directly to mains, pretty substantial amount of energy gets dumped into the wax over few AC line cycles. In that application (and also in most industrial automation situations) ~100ms is more than fast enough because when most of the effector components are AC powered you end up with ~40ms worst case actuation delay just from the physics of AC electricity. On my washing machine it is quite noticeable that when you press "start" the door gets positively locked well before the capacitive sensing "button" finishes playing its haptic feedback non-sense. (the fact that front panel of cheap-ish toploading washing machine is actually a huge touchpad with haptic feedback that is designed to look and behave like five physical buttons says many things about economics of manufacturing stuff for that somewhat hostile environment at these scales)

From the linked page:

> When a cycle is started, a wax motor is actuated pushing a pin outward and locking the door. This design has cost, reliability and safety advantages. In moist conditions a wax motor costs less for equivalent reliability than an electromagnetic solenoid or motor latch. It has a predictable passive release delay. If power is lost the door remains briefly locked, designed to be longer than the high speed spin cycle coast-down time, then reliably unlocks as the wax cools.