"My phone is a server now"
would've been better
--
> built in battery backup
Isn't it always recommended to remove battery if you plan to use a phone or a laptop as a server? ( Fire hazard )
or is it fine to just limit the charging to 80%?
would've been better
--
> built in battery backup
Isn't it always recommended to remove battery if you plan to use a phone or a laptop as a server? ( Fire hazard )
or is it fine to just limit the charging to 80%?
See also, this atomic clock wristwatch: http://leapsecond.com/pages/atomic-bill/
By saying "my server is now ..." implies a change of server platform to a phone but not where it came from.
Your offering: "my phone is a server now" implies a change of phone usage but does not indicate where the server came from.
The article itself tells all.
Except the original title is "my server is a phone now", not "my server is now...".
When I read the title, I literally thought "wow, I've seen a lot of people make servers out of old unused phones, but this is the first time I've heard someone make a phone out of an old unused server!"
Edit: Or I should say, it was 20 years ago. Maybe modern stuff is worse, but my M2 MacBook Air and Framework 13 Intel Core both power on without a battery.
LiPo batteries will fail over time if left fully charged. If you don't need the battery it's best to keep it somewhere around 40%. If 80% is the only option, that's usually good enough.
The primary failure mode starts when the cells are charged near their maximum voltage and kept there.
Not really. No sign of a phone. Just a computer — same as what all other servers run on.
"My server runs on a computer with a form factor that is atypical for server workloads" gets a little closer to the heart of the article, but even then it seems the real meat of it is about Android, not the hardware (although that is mentioned too).
How about "My server runs on Android"?
But in other hand, it is probably a pain in the ass to remove the battery and do some workarounds to make sure the phone correctly behaves without it.
'Very quickly' seems to be measured in decades from what I see
Most people I know have their laptop docked, either near-permanently at home or taking it between home and a desk with dock (so it's nearly always plugged in when in use)
The 'servers' I've had were all old laptops - yes, with battery (don't have to buy a separate UPS if one is already included). I've now also had two non-server laptops that were plugged into power pretty much all the time. I treated my first laptop perfectly: taking out the battery anytime I'd be in a classroom for several hours and it was already full enough (you know, back when sliding out your battery was possible in the first place), but I'm not noticing any faster degradation on the systems I treat poorly. I'll activate the 80% cap function where it exists (that is, in the latest phones and my work laptop's UEFI config panel), but the evidence of it being helpful has yet to materialize
I have read that studies show that charging to 100% causes degradation and I trust those more than random people's anecdotes (and I'm a random person), but I'm starting to wonder if I've maybe just misunderstood the study results. Maybe it's like how smoking increases your chance for some cancers but you might also be fine in the end. I see people with plenty of much younger and better-treated batteries that can't sustain literally 30 seconds of use whereas mine are reasonably close to the new state (some haven't had many charge cycles, just sat at a stressy high voltage all the time, which was indeed supposed to destroy them), and I don't know how to explain that otherwise
Anyway, my point is, maybe his phone has some mechanism similar to laptops to prevent this kind of thing, but in the end it's a phone. It's not the intended use for it.
The phone's battery can be reported to Home Assistant, where an automation can be triggered to turn off power to the phone when the battery gets above a certain percentage and turned back on when it goes below.
Not the best solution, but certainly an alternative from messing around with trying to get the phone to work without a battery.
Agree! But do get one or two of those "small automatic fire extinguisher" or whatever they are, that you can attach on stuff, for electrical panels and what not, and put right next to it together with a traditional fire alarm, and you're good to go :)
Putting the phone into a metal box, and the box, onto something not flammable, would help.
Maybe eventually everything around it can be so wet/burned out that the battery fire slowly just ends? The room would probably be fucked anyway...
In normal conditions, you use the product while it’s active. But with a server you are not daily checking.
You might have a bug in your changing limit. I think the constant higher temperature could also become an issue.