Also 240V power strips are fairly common in my circles because GPU server PSUs tend to be more efficient at 240V. They're marketed as PDUs, not strips. You're not gonna install a new outlet for every server. One dryer outlet in the garage is enough for most people
Re 120V outlets, while batteries don't need to supply the full peak load, they are more effective the more of it they can supply. And a home with a heat pump or baseboard heaters, electric range, EV charger, or dryer for example is going to at times significantly exceed the capacity of the 120/15 outlet. Doesn't mean the battery would be useless, just that it wouldn't be as effective at its primary purpose of load shifting as a 240V system, and therefore less economical.
Heat pumps and baseboard heaters are pretty uncommon in the US. Natgas furnaces are nearly 100% efficient so I don't expect that to change any time soon
NG may be 100% efficient, but heat pumps are like 300%+ in terms of electricity to indoor heat. And you get air conditioning.
You can get 10kWh of batteries and a 5kW MPPT chargeverter for a little over $2k these days (UL certified). A 30 kWh system with inverter can be had for around $4k. That’s well within the reach of most households.
If you’re on a 120v system, there’s a ~50/50 chance that your load is on the wrong side (except for 240v loads where you’ll imbalance things a tad but it should average out).
Unless you’re in an apartment/conso and have 208v instead of 240v… dunno what happens then.
Not really. My parents have all natural gas for the furnance, oven, stove, clothes dryer, and water heater; no air conditioner. Everything else is lights and outlets. There are no 240v outlets and no 240v breakers other than the main breaker.
Elsewhere in Europe it varies. Even small properties in Denmark and I think Germany have a three phase supply, my oven and stove use it directly.
When you have "three phase 415v", the 415v is the phase-to-phase voltage. Unlike the US 180 degree split phase 220v or 208v p2p, consumer equipment is not wired phase-to-phase unless it is 3-phase.
It's interesting that Europe has 3 phase cooktops, we usually see 32A single phase in Australia, homes rarely need more than 7kW per circuit. Aircons, pool heat pumps and EV chargers are the 3p loads.
Getting a 3 phase PV inverter is worthwhile if you have sun synchronous loads, like pool heater/chillers, across the phases. Then you will want a 3p battery inverter for the same reasons.