It's also nice that this has been solved for Blu-ray as well. You just have to buy the correct kind of Blu-ray drive, and there's custom firmware out there to flash on the drive and let you rip any Blu-ray.
It's annoying if you have some more obscure blu-ray release that nobody else has ripped, and even more so if you don't know a guy who can do you a favour.
I can take a $120 gamble to just buy a USB BD-drive and hope the disc isn't DRM'ed enough to make it a problem, but I'd rather just be sure and grab a drive that can rip everything. Unfortunately, because we can't have anything nice, scalpers make these drives impossible to obtain.
Meanwhile the cheapest external drive I can quickly find on Amazon is $35, just under half as much as I paid, or about a bit under a third for the same drive today. Either way it's far less than 10-20x.
From what I can tell, the affordable BD players cannot play all discs. They can read (and probably write) all data discs, but when I buy a disc, there's no guarantee I will be able to rip it and make it accessible over my LAN. That's the kind of drive I want, and that's what ends up getting scalped.
It only takes a little bit of research, and there are plenty that are not being scalped (or probably more commonly, scooped up by people who intend to use them). I found some in EU pricing in just a minute of searching. The MakeMKV forums are full of suggestions for suitable drives.
Just in case you didn't mean to be snarky, I was asking what the custom firmware brings to the device that allows using it to rip blu-ray discs that could not be ripped using the stock firmware.
Blu-ray is DRMed, so the stock firmware is capable of telling you 'no'. You don't always get direct access to the bits on the disc with the stock firmware (you can write your own discs that aren't protected, but store-bought ROM-discs are (always?) encrypted. The flashed firmware gives you direct access to the bits on the disc no matter what (region codes don't matter, the encryption doesn't matter, since your custom firmware will happily decode the disc and just hand you the files on it).
(And region codes aren't what I think of today as DRM. They've never been much more than silly speed bumps, so I wouldn't expect them to be at the heart of what's going on here.)
They do, because a key can be obtained externally, such as with a software library made for decrypting the discs.
In any case, thanks; I think I finally understand what's going on here. Based on what you've written, custom firmware is not actually required, but it makes things more convenient (especially for folks without much technical experience).
This is correct for normal blu-rays, but not the UHD ones, since they add another layer of encryption. There's some nonsense going on with VUKs and MakeMKV not being able to decrypt all UHD discs, since some are encrypted with keys that aren't easily available (though you can send in a dump of the disc to the devs and they'll often change that fact for that disc).
If you know of a software library that can decrypt any random UHD disc without external keys, then please, do tell, since the MakeMKV people apparently don't know about it.