It's a shame they're going in such an anti-consumer direction, both with their gaslighting customer support and the lawfare against Orca.
It's a shame they're going in such an anti-consumer direction, both with their gaslighting customer support and the lawfare against Orca.
However - yes, they did have me perform multiple disassembly/re-connect steps and document, and then of course every question/answer was at least a 24-hr turnaround (some delays were because I keep my printer at my office and chose to work from home a few times), eventually they sent me an entire new Vortek rack - which, once installed worked perfectly.
I was not looking forward to packing the entire thing up and shipping it back.
hmmm - they never asked for the old one back... (hmmm, harvest the servo motor? drag-chains and rods for other projects? Mount it on the wall and use it to store extra induction nozzles? Ideas?)
But it left a really bad taste in my mouth about the company.
Consumers are used to stuff like Amazon customer service. I wasn’t expecting to waste all that time to exchange 1kg of filament. I thought they’d send it out no hassle and take back the defective filament to research it themselves.
So now when I recommend Bambu, I say the printers are great but their customer service is horrible. So be very careful.
I assume you have an ams 2 pro?
And it won’t pull filament when randomly ?
Her also same issue and she’s having to fight them.
Shit is wild.
I feel rather guilty I had an initially good experience with my p2s, but they’ve managed to mess up the firmware or something ….
Now I don’t think I would recommend it to anyone anymore.