Hacker News Reader

Comment by the_mitsuhiko | Hacker News Reader

CF-ABS

> An alternative construction method for the air induction elbow, shown in the Cozy Mk IV plans, is a lamination of four layers of bi-directional glassfibre cloth with epoxy resin. The epoxy resin specified for the laminate has a glass transition temperature of 84°C, after the finished part has been post-cured. The aircraft owner stated that as the glass transition temperature listed for the CF-ABS material was higher than the epoxy resin, he was satisfied the component was fit for use in this application when it was installed

https://assets.publishing.service.gov.uk/media/69297a4e345e3...

View on HN

What a misunderstanding -- glass transition temperature means different things for thermoplastics (i.e. anything that comes out of an FDM printer like the CF-ABS in question) and for thermosetting resins like epoxy that actually undergo molecular cross-linking during the curing phase. Thermoplastics will get soft and can deform without limit, while thermosets get rubbery but still more or less hold their formed shape.

I think an extended quote shows that this was a really bad call:

“ The aircraft owner stated that as the glass transition temperature listed for the CF-ABS material was higher than the epoxy resin, he was satisfied the component was fit for use in this application when it was installed. A review of the design of the laminated induction elbow in the Cozy Mk IV plans showed that it featured a section of thin-walled aluminium tube at the inlet end of the elbow, where the air filter is attached. The aluminium tube provides a degree of temperature-insensitive structural support for the inlet end of the elbow. The 3D-printed induction elbow on G-BYLZ did not include a similar section of aluminium tube at the inlet end. Tests and research Two samples from the air induction elbow were subjected to testing, using a heat-flux differential scanning calorimeter, to determine their glass transition temperature. The measured glass transition temperature for the first sample was 52.8°C, and 54.0°C for the second sample.“

> The epoxy resin specified for the laminate has a glass transition temperature of 84°C

This seems very low for the kinds of epoxy I've used. I wonder if the manufacturer specs are highly conservative? Or maybe the material has a shortened lifespan with even moderate temperatures?

I was thinking about the ABS in the article and wondering if I would have made the same mistake. Close to every car manufactured today has plastic intakes, usually bolted right on top of the engine. The incoming air should help keep it cool, especially on aircraft. Maybe it was the radiant heat from a nearby cylinder that melted it?

There are some incredibly low Tg epoxies out there, such as West Systems 105 where "TG onset" is 54°C and the heat deflection temperature is even lower.

Reply on news.ycombinator.com