> had one fly for over a year at 40k ft
inquiring minds want to know. was this tethered? what kind of clearance did you need and what kind of equipment was necessary for safety purposes?
inquiring minds want to know. was this tethered? what kind of clearance did you need and what kind of equipment was necessary for safety purposes?
https://balloons.online/orbs-32-clear/
I used 36 awg wire and fishing line. The lower half of the dipole is also 36 awg wire.
No flight clearances are required
If any aircraft were to hit it, then it would be obliterated. This includes Cessna’s as well
Doubt it’d cause an immediate issue, but doesn’t sound very fun to remove.
Also it’s not 40k ft of wire. Altitude is 40k ft
The wire is about 16 ft for one leg of the dipole. That is the taught part. The other just floats in mid air underneath the payload
The community is very small and doubtful the sky will be filled with them
The balloons follow the jetstream from where they are launched. I have seen them fly over the Artic Circle, for example
How did you communicate with it? Amateur bands? LoRa?
Both top and lower part of dipoles are soldered to Raspberry Pi
It uses WSPR. Some of them use APRS but it is less common
You're nearing the altitudes at which the tensile strength of even supermaterials like Dyneema fibers are unable to lift the weight of their own tail, much less hold up against the tension of the jet stream. You'd need some kind of reverse rocket equation pyramid, where the topmost thousand meters have to lift the entire line, and are therefore made from line 0.6mm in diameter, and the next thousand meters are made of a slightly thinner, slightly less strong, slightly lighter fiber (because they don't have to lift the top thousand meters of line), and so on for the next 50-100km, depending on how much sag you expect the line to have.
"Oops, the balloon popped, excuse me while I do an ultramarathon across town spooling up my thousand-dollar tether from everyone's backyards...please don't cut it or trip over it or drive over it..."
No, it merely trails a 5 meter length of wire that acts as an antenna. You can receive the signals from hundreds of amateur receivers set up across the globe, often receiving transmissions at very long ranges. When the balloon eventually falls, yes, it's litter, but it's only a couple grams - go to your local park and pick up some trash, you can atone for a lifetime of HAB hobby sins with a single black bag full of alcohol bottles, fast food wrappers, and cigarette buts.
yet you can't say never, hence the question. balloons are launched for different purposes. if you're trying to keep a balloon on station to gather local data, it's gotta be tethered. maybe not typical of a 40k' altitude, but they definitely use tethered balloons.
[0] https://size-charts.com/topics/house-size-chart/wire-size-ch...
I do suspect if you encountered small gauge fishing line being used as a tether, you’d find at least some of it wrapped tightly around your spinner on the ground. Probably not much friction at play.
https://www.zachtek.com/product-page/wspr-tx-pico-transmitte...
Solar cells are polycrystalline. You can buy them on AliExpress (very brittle - takes practice soldering them)
I didn’t use the Traquito Solar truss. Too hard to solder. I used a foam dinner plate and solar tabbing wire