Well yes and no. Let's steer around the usual car analogy:

I own a drill driver that delivers enough torque that it could cause a nasty wrist injury. Most of the time all is fine.

===== feel free to ignore this waffle =====

Screws will generally cam out first, when it is miss-applied - ie the driver jumps out of the screw and probably destroys the tracks in the screw head. You eventually learn the correct torque and speed settings etc. Drilling - hammer or not (conc/brick or wood/plastic), speed etc. Again, you eventually learn how to drill efficiently.

Then you put something like a 50cm long 16mm auger bit in. An auger bit is basically a sharp edged corkscrew shaped drill bit that is designed to drill a fairly wide and very deep hole in wood. There are also paddle bits which are flat paddle shaped (quelle surprise) with a pointy part to start the hole and guide the main part of the tool. These generally are used for wider and shallower holes than augers.

So you stab your long auger into say a sleeper (150mm thick, hardwood). The sleeper is part of a wall. Friction soon becomes an issue - around 30cm down or earlier for slightly built people. If you know what you are doing, you position a leg in such a way that the handle of the drill/driver hits it (in the horizontal plane) and your wrist is safe.

===== /feel free to ignore this waffle =====

I generally find that <statement> followed by ... "you're doing it wrong" is unhelpful. Why not critique what is on offer instead of a put down with no working?