Brother is still good. The main issue is the usual one: It stops printing when toner is a bit low even though you could probably still print another 50-100 pages. But you'll find workarounds on the Internet.
Was quite frustrating but nowhere near as bad of some of the HP stories like this that I read on HN.
To enable Continue Mode, perform the following steps:
1. Press Menu.
2. Press ▲ or ▼ to select General Setup. Press OK.
3. Press ▲ or ▼ to select Replace Toner. Press OK.
4. Press ▲ or ▼ to select Continue. Press OK.
5. Press Stop/Exit.