> otherwise your home battery might be attempting to power the entire (local) grid which of course doesn't work.
and some random line worker may think there's no electricity flowing when there is.
and some random line worker may think there's no electricity flowing when there is.
(But yes, backfeeding the grid during an outage is dangerous and highly against code.)
If you have lines in an unknown state, step 1 is to put them in a known state. For power line work, this involves grounding all the phases and neutral together at both ends of the section you intend to work on. Good luck ringing a dead short with your home inverter/generator/etc.
Is that conceptualisation correct?
What happens is you have say a conductive (iron rich) top layer. Is there still the potential to dangerously energise the ground? I assume so because that's basically what water and electricity does?
Grounding provides an alternate path for the flow of electricity, so if a wire comes loose and ends up touching a copper pipe or something the current gets routed into the ground rather than into pipes or flammable wood or something.
Dispersal over an area isn't directly the goal, but it helps. By dispersing the current into an extremely large object, you don't really have to worry about the object building up a charge to the point where you can't flow current into it anymore.
Yes, you can dangerously energize the ground. You can dangerously energize almost anything with enough voltage. E.g. a Tesla coil has enough voltage to conduct through air. Don't try to test it (obviously), but I don't think a standard 110V house grounding has enough voltage to dangerously energize ground over any significant distance.