Sulfur Lamp
en.wikipedia.org
en.wikipedia.org
Sulfur Lamp: 100 lumens per watt. [0]
Random LED Light bulb: 88.888 lumens per watt. [1]
~20% improvement.
[0] https://web.archive.org/web/20030818061414/http://195.178.16...
[1] https://www.amazon.com/TCP-Equivalent-Light-Bulbs-Non-Dimmab...
The real competitor of these "ten kilowatt" class bulbs is theater-type arc lamp type devices where you can't deal with the weird spectral effects of LEDs and other quantum mechanical goofiness... Today you can buy COTS xenon lamps that run around 40 or so watts/lumen, so 100 L/W is a nice upgrade for stage and film theaters.
I don't know what sportsball stadiums use for night games. For raw bulk ugly illumination, sodium discharge lamps are COTS around 150 or so L/W, far surpassing what the sulfur bulbs can do in the lab. Interesting thought experiment is immense capex was dropped to illuminate sportsball fields and replacing the lights makes half the demand go away... so are sportsball fields going to be twice as bright at night or recycle all that power company infrastructure or is legacy pro sportsball going away with the boomers before sulfur bulbs could arrive commercially or ?
I don't see an easy way to decouple the magnetron and stuff from the lamp for sale purposes. A kilowatt class xenon lamp runs over a hundred dollars and figure a kilowatt class microwave oven and its innards could double the cost of a sulfur lamp while halving the cost of the electricity... this is really bad news for theater goers... it'll make theaters even more capital intensive which means even more risk adverse. If you're tired of formulaic remakes now, imagine when financial risk is twice as high due to double the bulb cost, LOL.
I’m familiar with two kinds of high-power theatrical lighting: tungsten and discharge. Tungsten is inefficient and has poor power factor when dimmed. Discharge lamps can’t cycle quickly, so, as a practical matter, they are turned in well before a show starts (to make sure they all work!) and stay on, at full power, until after the show. A motorized shutter modulates the light output. This wasted tons of power when the shutter is closed.
LEDs can cycle essentially arbitrarily quickly, and a good driver gets a power factor near 1.
I think it would be interesting to design a theater lighting system with a DC bus. Tungsten lights (where needed) would be driven by PWM, and LEDs would be driven directly by PWM if the voltages matched or with a DC-DC converter otherwise. There would be a battery to even out the load to minimize demand charges.
I don’t know what a three-phase AC-to-DC converter rated for, say, 100kW would cost. You’d want one that can be controlled such that it can share load in a controlled manner with a battery on the DC side.
A circuit to drive a tungsten lamp at variable brightness off AC is cheap (a TRIAC and its driver) but has crap power factor. I imagine a MOSFET to drive the exact same tungsten lamp from DC at a few hundred Hz PWM would be almost as cheap and could be filtered to have a clean input waveform. (Or it could be driven above 20kHz to eliminate the annoying audible buzz that tungsten lamps make.)
A big LED driver (AC to DC, constant current or constant voltage plus some dimming mechanism) is not particularly cheap, and the nice ones are largeish. A pure 24V “dimmer” (12-48V in, same voltage out, adjustable PWM frequency, and DMX controls) can be had quite cheaply with excellent performance. A constant current driver would be more expensive, but a DC-input driver ought to be smaller and less expensive than a comparable AC-input driver, especially if you care about power factor and inrush current.
(Common commercial AC-input LED drivers often have godawful inrush current, because they have big filter caps to get good performance, and they don’t spend the extra money on fancy circuitry to limit the inrush current. This means that you can’t actually put 20A of driver on a 20A breaker because the inrush current will trip the breaker. With DC input, a much smaller filter cap should give comparable performance.)
Anyway, this is all mostly speculation, and economies of scale matter. But those DC DMX dimmers really do exist.)
Sulfur lamps have CRI < 80. High CRI (> 90) LEDs are real competitors to HID lamps here.
LEDs are cheaper, and, more importantly, already there.
Link where I can buy one?
Good for low light pollution too.
Popular in Australia; are they popular elsewhere?
This would be ideal for offering indoor sunlight substitutes.
The silicon-carbide electrode version might give the material basis, if not the original technique, a second chance.
The light was warm but had a custard yellow color to it that seemed monochromatic. Replaced with halogen lamps until something better comes along.
A not entirely insane, but only mostly insane, idea would be a dishwasher that had infinitely free energy and an extremely bright light source could clean dishes slowly by using immense amounts of light to grow rapid doubling algae, then cycle to mushroom darkness to eat the algae and food debris. So tens of kilowatts and distilled water for rinsing and you've got a space ship dishwasher. Of course with tens of kilowatts and distilled water, you'd be better off with thermal decomposition and autoclave functionality but maybe bio would be more popular for stylistic or marketing greenwashing purposes. I suppose on a space ship using your dishwasher to generate a couple kilos of O2 per day off food waste would be of some benefit to the life support system.
Even the pot growers shied away from this tech. The lacking red inhibited decent flowering. If you can't make an inroad there, you're almost guaranteed to fail.
I don't. I think people will abuse it, blind others on the road, and it will literally kill multiple people before they're made illegal (if they're not already - I have no idea what the regulations are for automotive lighting).