> The frequencies are what I'm confused by as well. To have a half mile range at relatively low powers it would need to be a low frequency band.
> I'm guessing they haven't bought licenses from the FCC, so my bet is that they're using the 900 MHz ISM band.
Seems likely, and probably even works in controlled tests over relatively short distances. 900MHz meshing radios certainly exist, like this one (no affiliation with them, haven't used the product): https://www.rajant.com/products/breadcrumb-wireless-nodes/lx...
>Even with a high 30 dB signal to noise ratio, the Shannon channel capacity in a 26 MHz band is 50 Mbps.
Impossible in urban areas without highly directional antennas (which aren't small). The effective noise floor in most even semi-developed areas I've worked in is ~-100 to -80dBm - it can be a struggle even with expensive radios and fixed infrastructure. 30dB SNR just isn't going to happen over any appreciable amount of range on this sort of device (a high gain parabolic dish? sure). Using all 26MHz of the spectrum with an omni directional antenna (again, as would be required) also isn't going to happen except over relatively short distances.
900MHz is good technology, and can get robust, long distance links with the right infrastructure (I most work on 1-10mi links). The limitations on a pocket sized device with a pocket sized antenna mean this is unlikely to work @ 900MHz- especially in their fantasized scenarios of being in areas with no cell phone coverage (cell carriers have access to better bands, and far better infrastructure).