3ms to complete codegen is orders of magnitude faster than I expected. Does that include everything necessary from making the change through actually synthesizing samples?
Just did some proper testing on a reasonably complex project, looks like I was about an order of magnitude off (to be fair it was 2AM here at the time, and I wasn't reading the numbers right haha). 30-40ms is still fast enough that you don't notice for the most part though. For this specific project, it breaks down roughly like this:
- ~1ms to build the new MIR based on the editor state
- ~5ms to process/run passes on the MIR (this involves some funky graph traversal which could very likely be optimized a lot)
- ~12ms to generate LLVM IR
- ~14ms in the LLVM JIT
In a project that makes good use of groups (nodes that contain a surface inside and then expose some controls back out) I'd expect this to be lower, since we only need to perform those operations on the surfaces that change.
Other than that, you're right that it might be a bit high. There's very likely parts of the lowering code which can be optimized, I just haven't had the need to yet.