Hacker News Reader

Comment by foofoo55 | Hacker News Reader

Using gpm=(hp x 1715 x efficiency)/psi and allowing for 90% pump efficiency along with max 1.93 hp continuous from a 15A 120VAC receptacle, we can simplify the pumping-water-with-a-North-American-receptacle equation to gpm=3000/psi. So 10k psi outputs only 0.3 gpm, 3000psi outputs 1gpm, and 2000psi spits out 1.5 gpm (the latter of which matches the output from the top electric pressure washers).

View on HN

And since they said that it uses 10-20% the water of a standard shower head...

A modern shower head uses about 2gpm, so we are talking about 0.2 to 0.4gpm. That would give us a pressure of about 7500 to 15000psi using your equation.

This is much more realistic. 3k psi will struggle to cut a cake.

As someone used to metric, this is probably the msot confusing comment chain I've read yet o.O

You don't measure cutting force in cakes?

For those that need it in metric, a cake is roughly equivalent to a scone...

At least in the UK, Her Majesties Customs and Excise tried to measure it in biscuits (which require 17.5% greater cutting force than cakes), but Mcvities prevailed in the courts.

We measure cutting force using a very old baguette held at the Bureau international des poids et mesures.

That sounds like the worst case to me. They are doing their demos with 7500 psi from an outboard pump and thinking that it's going to be a minor detail that can be worked out after the kickstarter succeeds to generate a workable pressure from 15A 120v.

If they told us the pressure they're using for their demos, some smarty with a slide-rule might call them on getting that from a normal wall outlet.

Reply on news.ycombinator.com